THIS TREATMENT SHOULD ONLY BE USED AS LAST RESORT...

TANKCANDY LLC HOLDS NO RESPONSABILITY WITH USE OF THIS PRODUCT. DO YOUR RESEARCH BEFORE HAND.

YOU MUST REMOVE ALL INVERTIBRETS BEFORE TREATMENT!!

Breakdown for how much Interceptor to use for White bugs.
2 pills = 46.0mg (23mg each) then divide that by 400 gallons and we get .115mg per gallon.

(46.0/400)=.115mg per gallon

The following is based off my 120 gallon system.

.115mg x 120 = 13.8mg for the first dose

We next must weight the pill. The pill I have weights 1.0grams. Divide the total weight of the pill (1.0g) by the amount of milbemycin (23.0mg) in each pill (1.0/23.0)=.0434783
We then multiply .043478 by 13.8mg (first Dosage)= .6grams

First Dose: Day 0

1. Turn OFF Skimmer/GFO/Carbon etc. (Keep OFF until day 2)
2. Mix .6 grams of Milbemycin Oxime into RO water until disovled
3. Pour slowly into tank where there is highflow

NOTE: REMOVE ALL INVERTIBRETS BEFORE TREATMENT!!

Day 2/48Hours

1. 25% water change
2. Turn ON Skimmer/GFO (Keep ON until day 7)

Day 7: Second Dose

1. Turn OFF Skimmer/GFO
2. Mix 1.2 grams of Milbemycin Oxime (Double dosage) into RO water until disovled
3. Pour slowly into tank where there is highflow

Day 9

1. 25-30% water change
2. Turn ON Skimmer/GFO

Day 14

1. 25% water change
2. Run a large amount of carbon for a week.

Day 16-18

1. Begin to add inverts slowly. Observe carefully